The full measured specification of the VALT case, taken from the Rev A2 bill of materials. Figures are from CAD and are verified against the prototype drawings.
Case
Closed dimensions
66 × 95 × 9.2 mm
Weight
87 g
Body
6061-T6 aluminium billet, CNC machined from a single block
Finish
Bead blasted, Type II satin anodised — the colour is in the metal, not painted on
Part count
16, bonded and potted into one block
Storage
Fresh pouch slots
8, in two rows of four
Slot dimensions
15.0 × 34.7 × 5.2 mm each
Pouch formats
Suits slim and all-white formats
Discard tray
1, full width, running the full depth beneath the slots
The discard tray is the part most cases leave out. Fresh and used pouches never share a compartment, so the spent one has somewhere to go that is not your pocket or the slot a fresh pouch will sit in next.
Lid
Action
Slides either way to magnetic detents and stops there
Travel
Approximately 53 mm to clear the body
Bearing surfaces
Titanium glide strips, hard coated
Strike surfaces
4 stainless steel strike pads
Mechanism
No hinge, no clip, no spring — nothing to snag or wear out
Phone attachment
System
MagSafe ring module and steel flux plate, bonded into the chassis
Alignment
Aligns and holds the way an official MagSafe accessory does
Phone-side contact
Hard-coated film, flush in the phone-side seat — no metal touches the phone
Verified fit
Every iPhone model through the 17 Pro, including camera clearance
Phone cases change the rear step and the camera lip, so fit with a case depends on the case. We are measuring against Apple and common third-party cases with a gauge before production, and will publish the list before orders open.
Care
Water
Not a sealed case. Do not submerge.
Cleaning
Bonded and potted joints are wash resistant — a splash or a wipe is fine.
Be first.
Only 500 cases in the first run. Everyone on the list orders first.